Impressão 3D: como reduzir tempo e filamento sem perder qualidade

Summary

Key Points

• Adjusting the 'only one wall on top surfaces' setting to 'not applied' and changing the top surface infill to concentric improved the finish and reduced print time. 1:34
• Experimenting with different support types, including normal, tree, and hybrid tree, showed varying impacts on print time and effectiveness. 2:39
• Manual support painting can be used for specific areas if automatic supports are not ideal, particularly for small overhangs. 3:13
• The presenter prefers gyroid infill at 7% over cubic or grid infill for a balance of strength, material usage, and print quality. 3:39
• Using three walls and the inner-outer wall setting can enhance the exterior finish and strength without significantly increasing filament usage. 4:18
• Switching to a 0.16mm layer height with adjusted speeds can improve the overall finish at the cost of a slightly longer print time. 4:36
• Using a generic high-speed filament resulted in a slightly longer print time compared to a standard generic filament when using high-quality settings. 5:32
• The initial print time of 2 hours and 50 minutes was reduced by changing the layer height from 0.12mm to 0.2mm standard. 5:44
• Printing at a 0.2mm standard layer height significantly reduced print time for a full plate compared to a 0.12mm layer height. 6:56
• The presenter recommends using a 0.16mm layer height for supports and adjusting spacing and Z-over-XY settings for easier removal and better finish. 8:06